leads4pass offers latest Cisco ICND2 200-105 dumps exam questions and answers download free try. High quality Cisco ICND2 200-105 dumps pdf practice materials and study guides free update. https://www.leads4pass.com/200-105.html dumps exam training resources. Get the best Cisco ICND2 200-105 dumps pdf files and dumps vce youtube demo, pass Cisco 200-105 exam test easily.
Download Free Latest Cisco 200-105 dumps pdf questions and answers: https://drive.google.com/open?id=0B_7qiYkH83VRS3BsT2duT3pTSlU
Download Free Latest Cisco 300-320 dumps pdf questions and answers: https://drive.google.com/open?id=0B_7qiYkH83VRU3Y3elpyNldxUU0
Vendor: Cisco
Certifications: ICND2
Exam Name: Interconnecting Cisco Networking Devices Part 2 (ICND2 v3.0)
Exam Code: 200-105
Total Questions: 204 Q&As
QUESTION 1
A dynamically routed private line and a statically routed IPsec tunnel connect two offices. What routing configuration prefers the IPsec tunnel only in the event of a private line failure?
A. floating static entry
B. EIGRP variance
C. bandwidth metric
D. OSPF maximum paths
Correct Answer: A
QUESTION 2
Which describes a best practice rule for controlling traffic between the corporate network and the controls network?
A. Outbound traffic from the control network to the corporate network and outbound traffic from the corporate network to the control network can be restricted based on source and destination address only.
B. Outbound traffic from the corporate network to the control network should be restricted but outbound traffic from the control network to the corporate network should not be restricted.
C. Outbound traffic from the control network to the corporate network should be restricted based on source and destination address and service only.
D. Outbound traffic from the control network to the corporate network should be restricted based on source and destination address, service, and port.
Correct Answer: D
QUESTION 3
What percentage of an I/O connection would you set the RPI in order to ensure the application has the most current data? 200-105 dumps
A. RPI at 50% of IO rate
B. RPI at 25% of IO rate
C. PI to 25% of PAC scan rate
D. Set RPI to 50% of PAC scan rate
Correct Answer: A
QUESTION 4
A lightweight AP has been deployed in local mode in a network that consists of 10 wireless LAN controllers in a single mobility group. The AP has been configured to use primary, secondary, and tertiary Cisco WLCs. Due to a major power failure, all those Cisco WLCs are unavailable. Which step does the AP take next?
A. The AP reboots and repeatedly attempts to join the configured primary, secondary, and tertiary Cisco WLCs in that order. The process continues until one of the configured Cisco WLCs is available.
B. The AP attempts to join a Cisco WLC configured as a master controller.
C. The AP attempts to join the Cisco WLC that has the greatest capacity available.
D. The AP state transitions to AP Fallback Mode and continues to provide limited WLAN services (that is, no new client authentications) until a Cisco WLC is available.
Correct Answer: B
QUESTION 5
Which statement is correct regarding Media Redundancy Protocol (MRP) in a ring of ProfiNET devices?
A. When a link fault is detected, MRP rings must converge in less than 100 milliseconds
B. MRP defines two device roles, Media Redundancy Master and Media Redundancy Client
C. MRP can support rings of up to 250 devices
D. MRP is only supported on network switches
Correct Answer: B
QUESTION 6
You want to gather as much detail as possible during a network audit, to include data time stamping across a large number of interfaces, customized according to interface, with a minimal impact on the network devices themselves. Which tool would you use to meet these requirements?
A. RMON
B. SNMPv3
C. NetFlow
D. Cisco Discovery Protocol
Correct Answer: C
QUESTION 7
Refer to the exhibit.
A packet with a source IP address of 192.168.2.4 and a destination IP address of 10.1.1.4 arrives at the AcmeB router. 200-105 dumps What action does the router take?
A. forwards the received packet out the Serial0/0 interface
B. forwards a packet containing an EIGRP advertisement out the Serial0/1 interface
C. forwards a packet containing an ICMP message out the FastEthemet0/0 interface
D. forwards a packet containing an ARP request out the FastEthemet0/1 interface
Correct Answer: C
QUESTION 8
Refer to the exhibit.
Why has this switch not been elected the root bridge for VLAN1?
A. It has more than one interface that is connected to the root network segment.
B. It is running RSTP while the elected root bridge is running 802.1d spanning tree.
C. It has a higher MAC address than the elected root bridge.
D. It has a higher bridge ID than the elected root bridge.
Correct Answer: D
QUESTION 9
Which is an issue with running CIP Motion on a REP network and identifies an alternate resiliency protocol that works for CIP Motion?
A. CIP Motion requires a star topology which is not supported by REP. DLR is a suitable resiliency protocol for CIP motion.
B. REP convergence is not fast enough. DLR is a suitable resiliency protocol for CIP motion.
C. CIP Motion requires a star topology which is not supported by REP. RPVST+ is a suitable resiliency protocol for CIP motion.
D. REP convergence is not fast enough. RPVST+ is a suitable resiliency protocol for CIP motion.
Correct Answer: B
QUESTION 10
When an AP, in its default configuration mode, connects to a Cisco WLC, which methods are available forremote management access to an AP?
A. SSL and SSH are available only after configuration by a Cisco WLC version 7.0.
B. SSH only
C. HTTPS, and SSH
D. SSH and Telnet
E. SSH and Telnet are available only after configuration by a Cisco WLC version 7.0.
Correct Answer: D
QUESTION 11
A shutdown in the cookie cutter machine was traced to a broken network cable. What are two reasons that explain why using DLR is an appropriate choice for network resiliency? 200-105 dumps (Choose two)
A. DLR is designed for single network operation at the machine level
B. Moving to a linear topology will reduce the number of cables and so reduce risk of cable failure
C. DLR is the only resiliency technology that is supported by CIP Safety
D. Layer 2 resiliency protocols like REP and RSTP do not have a fast enough convergence time for motion control
E. Half of the network traffic goes clockwise on the ring and the other half counterclockwise, reducing by 50% the impact of cable failure
Correct Answer: A,D
QUESTION 12
Which statement is true concerning the data center access layer design?
A. The access layer in the data center is typically built at Layer 3, which allows for better sharing of services across multiple servers.
B. With Layer 2 access, the default gateway for the servers can be configured at the access or aggregation layer.
C. A dual-homing NIC requires a VLAN or trunk between the two access switches to support the dual IP addresses on the two server links to two separate switches.
D. The access layer is normally not required, as dual homing is standard from the servers to the aggregation layer.
Correct Answer: B
Reference: https://www.leads4pass.com/200-105.html dumps exam questions and answers free update.
Watch the video to learn more: https://youtu.be/hZ-2ufhcg6s