Do you want to pass Cisco 300-115 dumps exam? Newest helpful Cisco CCDP 300-115 dumps exam practice questions and answers free download from leads4pass. High quality latest Cisco CCDP 300-115 dumps pdf materials and vce youtube demo update free shared. “Implementing Cisco IP Switched Networks” is the name of Cisco CCDP https://www.leads4pass.com/300-115.html exam dumps which covers all the knowledge points of the real Cisco CCDP. Latest useful Cisco CCDP 300-115 dumps pdf training resources and study guides download free try, 100% success and guarantee to pass Cisco 300-115 exam test quickly and easily at first attempt.
Latest Cisco 300-115 dumps pdf questions and answers: https://drive.google.com/open?id=0B_7qiYkH83VROUdnZWRYLTJta1E
Latest Cisco 300-135 dumps pdf questions and answers: https://drive.google.com/open?id=0B_7qiYkH83VRS21DRS14UlZHNjg
Best Cisco CCDP 300-115 dumps exam questions and answers (1-20)
QUESTION 1
A switch is added into the production network to increase port capacity. A network engineer is configuring the switch for DHCP snooping and IP Source Guard, but is unable to configure ip verify source under several of the interfaces.
Which option is the cause of the problem?
A. The local DHCP server is disabled prior to enabling IP Source Guard.
B. The interfaces are configured as Layer 3 using the no switchport command.
C. No VLANs exist on the switch and/or the switch is configured in VTP transparent mode.
D. The switch is configured for sdm prefer routing as the switched database management template.
E. The configured SVIs on the switch have been removed for the associated interfaces.
Correct Answer: B
QUESTION 2
Which command correctly configures standby tracking for group 1 using the default decrement priority value?
A. standby 1 track 100
B. standby 1 track 100 decrement 1
C. standby 1 track 100 decrement 5
D. standby 1 track 100 decrement 20
Correct Answer: A
QUESTION 3
Which database is used to determine the validity of an ARP packet based on a valid IP-to- MAC address binding?
A. DHCP snooping database
B. dynamic ARP database
C. dynamic routing database
D. static ARP database
Correct Answer: A
QUESTION 4
RSPAN has been configured on a Cisco Catalyst switch; however, traffic is not being replicated to the remote switch.
Which type of misconfiguration is a cause? 300-115 dumps
A. The RSPAN designated VLAN is missing the remote span command.
B. The local and remote RSPAN switches are configured using different session IDs.
C. The local RSPAN switch is replicating only Rx traffic to the remote switch.
D. The local switch isoverloaded with the amount of sourced traffic that must be replicated to the remote switch.
Correct Answer: A
QUESTION 5
Your customer has asked you to come in and verify the operation of routers R1 and R2 which are configured to use HSRP. They have questions about how these two devices will perform in the event of a device failure.
What issue is causing Router R1 and R2 to both be displayed as the HSRP active router for group 2?
A. The HSRP group number mismatch
B. The HSRP group authentication is misconfigured
C. The HSRP Hello packets are blocked
D. The HSRP timers mismatch
E. The HSRP group priorities are different
Correct Answer: B
QUESTION 6
It a switch stack is configured to used SDM templates, where are the templates stored?
A. stack master
B. TFTP server
C. flash memory
D. all stack members
Correct Answer: A
QUESTION 7
What is the default interval at which Cisco devices send Cisco Discovery Protocol advertisements?
A. 30 seconds
B. 60 seconds
C. 120 seconds
D. 300 seconds
Correct Answer: B
QUESTION 8
Which portion of AAA looks at what a user has access to?
A. authorization
B. authentication
C. accounting
D. auditing
Correct Answer: A
QUESTION 9
Refer to the exhibit.
When a network administrator is attempting an SSH connection to the device, in which order does the device check the login credentials?
A. RADIUS server, localusername, line password
B. RADIUS server, line password, local username
C. Line password, local username, RADIUS server
D. Line password, RADIUS server, local username
Correct Answer: A
QUESTION 10
Which statement about Layer 2 protocol participation of ports involved m a SPAN session is true?
A. Neither a SPAN source nor SPAN destination participates m any Layer 2 protocols.
B. A SPAN source does not participate n any Layer 2 protocols
C. A SPAN destination does not participate n any Layer 2 protocols
D. Both SPAN source and SPAN destination participate in any Layer 2 protocols
Correct Answer: C
QUESTION 11
An EtherChannel bundle has been established between a Cisco switch and a corporate web server. The network administrator noticed that only one of the EtherChannel links is being utilized to reach the web server. 300-115 dumps What should be done on the Cisco switch to allow for better EtherChannel utilization to the corporate web server?
A. Enable Cisco Express Forwarding to allow for more effective traffic sharing over the EtherChannel bundle.
B. Adjust the EtherChannel load-balancing method based on destination IP addresses.
C. Disable spanning tree on all interfaces that are participating in the EtherChannel bundle.
D. Use link-state tracking to allow for improved load balancing of traffic upon link failure to the server.
E. Adjust the EtherChannel load-balancing method based on source IP addresses.
Correct Answer: E
QUESTION 12
Routers R1 and R2 are configured for HSRP as shown below:
Router R1: interface ethernet 0 ip address 20.6.2.1 255.255.255.0 standby 35 ip 20.6.2.21 standby 35 priority 100 interface ethernet 1 ip address 20.6.1.1.2 255.255.255.0 standby 34 ip 20.6.1.21 Router R2: interface ethernet 0 ip address 20.6.2.2 255.255.255.0 standby 35 ip 20.6.2.21 interface ethernet 1 ip address 20.6.1.1.1 255.255.255.0 standby 34 ip 20.6.1.21 standby 34 priority 100 You have configured the routers R1 andamp;R2 with HSRP. While debugging router R2 you notice very frequent HSRP group state transitions. What is the most likely cause of this?
A. physical layer issues
B. no spanning tree loops
C. use of non-default HSRP timers
D. failure to set the command standby 35 preempt
Correct Answer: A
QUESTION 13
Refer to the exhibit. Based upon the output of show vlan on switch CAT2, what can we conclude about interfaces Fa0/13 and Fa0/14?
A. That interfaces Fa0/13 andFa0/14 are in VLAN 1
B. That interfaces Fa0/13 and Fa0/14 are down
C. That interfaces Fa0/13 and Fa0/14 are trunk interfaces
D. That interfaces Fa0/13 and Fa0/14 have a domain mismatch with another switch
E. That interfaces Fa0/13 and Fa0/14 have a duplexmismatch with another switch
Correct Answer: C
QUESTION 14
A Cisco Catalyst switch that is prone to reboots continues to rebuild the DHCP snooping database. What is the solution to avoid the snooping database from being rebuilt after everydevice reboot?
A. A DHCP snooping database agent should be configured.
B. Enable DHCP snooping for all VLANs that are associated with the switch.
C. Disable Option 82 for DHCP data insertion.
D. Use IP Source Guard to protect the DHCP binding table entries from being lost upon rebooting.
E. Apply ip dhcp snooping trust on all interfaces with dynamic addresses.
Correct Answer: A
QUESTION 15
Refer to the exhibit.
Which option describes the reason for this message in a GLBP configuration?
A. Unavailable GLBP active forwarder
B. Incorrect GLBP IP address
C. HSRP configured on same interface as GLBP
D. Layer 2 loop
Correct Answer: D
QUESTION 16
A network engineer changed the port speed and duplex setting of an existing EtherChannel bundle that uses the PAgP protocol. Which statement describes what happens to all ports in the bundle?
A. PAgP changes the port speed and duplex for all ports in the bundle.
B. PAgP drops the ports that do not match the configuration.
C. PAgP does not change the port speed and duplex for all ports in the bundle until the switch is rebooted.
D. PAgP changes the port speed but notthe duplex for all ports in the bundle.
Correct Answer: A
QUESTION 17
Whichfour LACP components are used to determine which hot-standby links become active after an interface failure within an EtherChannel bundle? 300-115 dumps (Choose four.)
A. LACP system priority
B. LACP port priority
C. interface MAC address
D. system ID
E. port number
F. hot-standby link identification number
G. interface bandwidth
Correct Answer: ABDE
QUESTION 18
Afterport security is deployed throughout an enterprise campus, the network team has been overwhelmed with port reset requests. They decide to configure the network to automate the process of re-enabling user ports.
Which command accomplishes this task?
A. switch(config)# errdisable recovery interval 180
B. switch(config)# errdisable recovery cause psecure-violation
C. switch(config)# switchport port-security protect
D. switch(config)# switchport port-security aging type inactivity
E. switch(config)# errdisablerecovery cause security-violation
Correct Answer: B
QUESTION 19
Refer to the exhibit.
Which EtherChannel negotiation protocol is configured on the interface f0/13 ?f0/15?
A. Link Combination Control Protocol
B. Port Aggregation Protocol
C. Port Combination Protocol
D. Link AggregationControl Protocol
Correct Answer: B
QUESTION 20
Which two statements about SPAN source and destination ports during an active session are true? (Choose two.)
A. The source port can be only an Ethernet physical port.
B. The source port can be monitored in multiple SPAN sessions.
C. Thedestination port can be destination in multiple SPAN sessions.
D. The destination port does not participate in STP.
E. You can mix individual source ports and source VLANs within a single session.
Correct Answer: BD
Here are some reviews from our customers:
You can click here to have a review about us: https://www.resellerratings.com/store/leads4pass
The best and most updated latest Cisco CCDP 300-115 dumps exam practice materials in PDF format free download from leads4pass. Useful latest Cisco CCDP https://www.leads4pass.com/300-115.html dumps pdf training resources which are the best for clearing 300-115 exam test, and to get certified by Cisco CCDP, free download with high pass rate.
High quality Cisco CCDP 300-115 dumps vce youtube: https://youtu.be/wyXFLuYtFpI
Why Choose Lead 4 Pass?
leads4pass is the best provider of IT learning materials and it is the right choice for you to prepare for the exam. Other brands started earlier, but the price is relatively expensive and the questions are outdated. leads4pass offers the latest real questions and answers with cheaper prices, help you pass the exam easily at first try.
